■ INPUT (A & B) :
● CURRENT
– Programmable range : -20 mA ~ +20 mA DC
– Measurement range : ±21 mA Max.
– Input resistance : 50Ω(0.5W)
● LOOP POWERED CURRENT
– Supply Voltage : 18 ~25 VDC(Terminal) / 4~20mA
● VOLTAGE :
– Programmable Range : -10V ~ +10V DC
– Measurement range : ±11 V Max.
– Input resistance Normal : 1 MΩ
● ANALOG OUTPUT :
– DC Current : 0(4)~20 mA DC max. ( Load resistance : 600Ω max. )
– DC Voltage : -10V min. ~ +10V DC max. ( Load Resistance : 10 KΩ or more )
– 2-Wire Transmitter(4~20mA DC), supply out voltage (9 V ~ 35 V DC)
– Easy Calibration of the Gain (Max. ±5% of F.S) and Offset(Max. ±5% of F.S).
● FREQUENCY OUTPUT (Hz) : Voltage / Open Collect(Drain)
■ FUNCTIONS
– Analog Calculations
[000] Normal input (A)
[001] Square Root (A)
[002] Root Extraction (A)
[007] ADDER(A+B) : Addition of 2 analog inputs
[008] SUBTRACTOR(A-B) : Subtraction of 2 analog inputs
[009] MULTIPLIER(A*B) : Multiplication of 2 analog inputs
[010] DIVIDER(A/B) : Division of 2 analog inputs
[011] HSS(AorB) High Signal Selection [LARGER]
[012] LSS(AorB) Low Signal Selection [SMALLER]
[101] Normal input (B)
[102] Square Root (B)
[103] Root Extraction (B)
[108] SUBTRACTOR(B-A) : Subtraction of 2 analog inputs
[109] DIVIDER(B/A) : Division of 2 analog inputs
-Peak-Hold
[004] Peak-Hold(Higher)(A)
[005] Peak-Hold(Lower)(A)
[006] Peak-Hold(High/Low)(A)
[105] Peak-Hold(Higher)(B)
[106] Peak-Hold(Lower)(B)
[107] Peak-Hold(High/Low)(B)
-Counter
[003] INTEGRATOR (A) : Count of input range by count rate (Count Per Hour).
[103] INTEGRATOR (B) : Count of input range by count rate (Count Per Hour).
– Two Converters
[201] Two Converters [input-A to Output-1, input-B to output-2]
-Communications
MODBUS PROTOCOL (RTU) or other protocols
** Default set – Serial Port (1,2) **
– Baudrate : 19200 (set value “192″)
– Data Bit : 8
– Start Bit : 1
– Stop Bit : 1
– Parity Bit : None
